B-band Ukko Bedienungsanleitung

1UKKO DRUM CONTACT MICS BY B-BANDI N S T A L L A T I O N I N S T R C U T I O N S 1 / 2 0 0 8™

10114. Once the placement is found, remove the adhe-sive cover and stick to place.

10115. The loose lead wire of the mic should be at-tached to the drum shell by using double-sided tape (not supplied).6. Open UKKO pr

12139. If the depth of the drum is so the preamp does not t straight vertically between the bottom and top hoops, then, in most cases, the pre

1213Thread the connector and lead wire through air hole and hole at the middle of the preamp, keeping the preamp at the side of the shell. Brin

141514. Close preamp. 15. Install drumhead and rim.16. Plug in a XLR cable to the preamp and to a mixer, or other audio equipment, that can sup

14151. -6dB High Cut (shelving > 8 kHz) ON / OFF2. +3dB Mid Boost 500 Hz (peaking Q ~1) ON / OFFUKKO-T Tom:1. +6dB High Boost 5 kHz (peaking Q ~1)

1617www.b-band.comInternational:B-Band LtdKonttisentie 8, 40800 Vaajakoski, FinlandTel: +358 14 332 9050Fax: +358 14 332 9001. Email: [email protected]

1617

2HIGH TECHNOLOGY WITH SPIRITCongratulations and thank you for your purchase of this UKKO contact mic system for drums.B-Band takes care to provide th

32PACKAGE CONTENTS CHECKLISTUKKO-PACK package contents:• 5 pcs UKKO contact mic• 10 pcs extra replacement tape for contact mic• 1 pcs UKKO snare dr

45Before installation, make sure the instrument is in good working condition. UKKO series preamps are phantom powered only. Useful voltage is 15 to 48

45contact mics. These are made available in case you want to change the place of the contact mic, or change the mic to another drum. It is

675. The connector and lead wire from the contact mic goes through the air hole to the preamp. The air hole needs to be 5mm (0.197” or about 3/16”) in

678. Install drumhead and rim. 9. Using the supplied tool, open preamp by insert-ing at the slot at top, push in and turn carefully.10. Take the short

8911. Attach rim mount. Rim mount can be removed just by reversing the pictured process.12. Connect mic to preamp to the horizontal pin connect

89™13. Set tone controls (mini switches - see page 14). 14. Attach preamp cover. 15. Plug in a XLR cable to the preamp and to a mix