1INSTALLATION MANUALB-BAND A2.2 XOM™ ONBOARD PREAMP WITH B-BAND UST AND AST TRANSDUCER This is a basic installation manual and tip sheet. For mo
101110. TROUBLE SHOOTING10.1 No sound at all or intermittent sound• Check the guitar cable and amplifier / mixer you are using.• Check that the batter
1011problem is due to unequal pressure distribution, not bad me-chanical contact. In this case, add the paper underneath the louder strings. Try this
1213LED’s in this product are Class 1 in accordance to EN 60825-1. Statement of EU Declaration of Conformity is available from manufacturer up
121350 / 50 MIX OF AST & USTFULL RANGE USTB-BAND LIMITED WARRANTY STATEMENTIn the unlikely event that your product needs guarantee service, please
1415to wear and tear.b) consumables (components that are expected to require peri-odic replacement during the lifetime of a product)c) damage or defec
1415liability limitations, the higher limitations apply.YOUR LEGAL RIGHTS RESERVEDConsumers have legal (statutory) rights under applicable national la
16International:B-Band LtdKonttisentie 8, 02150 Vaajakoski, FinlandTel: +358 14 332 9050Fax: +358 14 332 9001Email: [email protected]: www.b-ba
DEAR CUSTOMER,Thank you very much for purchasing this state-of-the-art B-Band® acoustic transducer system. B-Band takes care to provide
1. SAFETY AND PRODUCT CAUTIONSAlthough B-Band products could be easy to install by following these instructions carefully and checking the B-Band webs
45B-Band model #: 29RUST width: 3.0 mm (.118” (1/8”))3. OVERVIEW OF A2.2 PREAMP WITH XOMThe A2.2 is an onboard preamp with a remote soundhole control
45 ing on the width of the transducer• Wood or metal drill bit, 3 mm (.12”)• Screwdriver, Posidriv #1• Endpin reamer, 12 mm (.47”) or wood drill b
67Adhesive sideparallel under the bridge. The AST should be placed so that the AST is on the bass side of the brace running parallel to the strings an
67inserting a 9-volt battery in and out of it to learn how it works. Once this is checked, find a convenient place inside the guitar where the battery
898. INSTALLING THE PREAMPFor the next portion of the installation, be careful not to catch the pickup on anything as you work; inadvertent tugging ma
89For AST remove the adhesive protective layer from the AST. Then stick it firmly by holding and pressing with fingers for a short while. If ne
Kommentare zu diesen Handbüchern